E72Reference SectionError MessagesThe following table lists the error messages and other warnings displayed in themonitor, as well as the solutions for dealing with them.Display Cause/Solution AO (flashes) Clock not set.Set date and time. E50Battery exhausted. Charge or replace the battery. 14, 16Battery temperaturehighBattery temperature is high.Turn off camera, and allow battery to cool down beforeresuming use. After five seconds, the monitor will turn offand the power-on lamp will flash rapidly. After the lampsflash for three minutes, the camera will turn offautomatically. Pressing the power switch also turns offthe camera.21The camera will turnoff to preventoverheating.The camera has become hot.The camera turns off automatically. Leave the camera offuntil it has cooled and then turn it on again.80Q (● flashes red)Camera cannot focus.• Refocus.• Use focus lock.26, 2967Please wait for thecamera to finishrecording.Camera cannot perform other operations until recordingis complete.Wait until message clears from display automaticallywhen recording is complete.–Memory card iswrite protected.Write-protect switch is in “lock” position.Slide write-protect switch to “write” position. –Not available if Eye-Fi card is locked.Write-protect switch of Eye-Fi card is in “lock” position.Slide the write-protect switch to “write” position. –Error accessing Eye-Fi card.• Use an approved card.• Check that terminals are clean.• Confirm that Eye-Fi card is correctly inserted.E661818This card cannot beused. Error accessing memory card.• Use approved card.• Check that connectors are clean.• Confirm that memory card is correctly inserted.191818This card cannot beread.
