Nikon R1 Instruction Manual

Contents

1122 Procedures for close-up flash operation (using cords)1 Turn on the camera and SU-800.After turning on the camera, press the [ON/OFF]button on the SU-800 to turn on the SU-800 andSB-R200.• The red ready-lights on the SU-800 and SB-R200come on when fully recycled.• Make sure that Close-up mode and Using cordsindicators appear on the LCD panel.2 Setting the flash mode on the SU-800Press the [MODE] button on the SU-800 to set theflash mode to TTL BL, TTL or M.3 Activating or canceling the SB-R200’s flash firingPress the [A B] select button to set the remoteflash units in Group A or B to fire or to cancel.• A remote flash unit on the left as viewed from theSU-800’s LCD panel is assigned to Group A, and aflash unit on the right is assigned to Group B.• A flash canceled group indicator disappears.• You cannot cancel flash firing for both Groups A and B.4 Setting the flash output level compensation (in TTLBL or TTL mode)Press the [SEL](FUNC.), or [] or [] button todisplay the flash output level compensation value(blinking). Press the [] or [] button to increaseor decrease the compensation value. Press the[SEL](FUNC.) button once again and the value willstop blinking. The last value to blink is the one thathas been set automatically.• The same value is set for both groups A and B.• Flash output level compensation values can be set in1/3 step increments or decrements from +3.0 to -3.0 EV.• The values are displayed in decimal format, like 0.3 for1/3, and 0.7 for 2/3.• Pressing the [] or [] button continuously increasesor decreases the value quickly.• The compensation value blinks during adjustment andstops after blinking six times unless an adjustment ismade. The last value to blink is the one that has beenset automatically.• If the flash output level compensation value is set 0.0,the display goes off.• Being able to set flash output level compensation isdependant on camera in use.READYLOMODENO AF-ILL SELA B