Nilfisk-Advance Captor 4300 Quick Start Manual

Also see for Captor 4300: Mechanical repair service manual Instructions for use Quick start troubleshooting manual

Nilfisk-Advance Captor 4300 Quick Start Manual Manual pdf 10 page image

88888 - FORM NO. 56043093 / Captor ™ 4300, 4800, 5400 / CR 1100, 1200, 1400Copyright 2003 Nilfisk-Advance. Page 1 of 2 10/14/2003Advance Captor 4300/4800/5400 G/P/DNilfisk CR 1100/1200/1400 G/P/DPM ChecklistDefect CodesCustomer A needs adjustmentB bindingAddress C dirty or contaminatedD damaged, bent or tornCity St Zip L leaksM missingModel Serial Hours W worn outRefOPERATIONAL INSPECTION ITEMSOKDefect Codes(circle)DoesNotWork1 Check Neutral Safety Switch Operation (To test depress drive pedal and start theengine, it should not start.)A B C2 Engine Starting with pedal in neutral (if it will not start check neutral safety switch) A3 Engine Idle 1200rpms A rough4 Engine High Speed (high switch setting) 2400 RPM A low power5 Drive Pedal Linkage (check for FWD/REV drive and any neutral creep) A B6 Drive System Performance Noisy sluggish7 Brakes (check both service & parking) A B W8 Steering excessive play9 Hopper Up/Down (also check operation of the safety hopper support) A B10 Hopper Dump Door Open/Close A B11 Main Broom Raise /Lower A B12 Side Broom Raise /Lower A B C13 Main Broom On/Off (will drift) A B C14 Side Broom On/Off <----->15 Scrub System (Raise/Lower and auto scrubbing functions) <----->16 Scrub Brush (pressure settings 1,2 &3) A B17 Squeegee System (Raise/Lower and Auto Lift in Reverse) A B18 Vacuum Performance (Sealed water lift 22" and 1- inch open hole adapter 20 inches) C L W19 Solution Control (On/Off and Flow Volume Min/Max) C L20 Perform the machine self-diagnostic test. (see manual PN 56043093) <----->21 Headlights, Gauges and (optional) accessories Rotating Beacon, Backup Alarm <----->22 Dust Control Filter Shaker & Impeller <----->23 Tilt Steering Mechanism and Seat Adjustment lever A BRefVISUAL INSPECTION ITEMSComments OKDefect Codes(circle)DoesNotWork24 Side Broom Height (min bristle wear 3 inches) A B D W25 Side Broom Motor B L26 Hopper Cover Gasket D W27 Hopper Dust Filter & Gasket D W28 Impeller Motor (remove cover to access motor, fan & valve) C L W29 Hopper Dump Door Cylinder A B L30 Hopper Skirting & Seals (raise hopper to inspect) D M W31 Hopper Dump Door & Seal A B D W32 Brake Cable, Brake Shoes & Drum Wear A B W33 Hopper Lift Cylinder & Magnetic Switch A B L34 Main Broom Pattern Adjustment (min bristle wear 2-1/2"6.4cm length) & Magnetic on/off broom switch2" (5 cm) wide pattern A B D W35 Main Broom Motor (open left side access door to inspect) B L