Nilfisk-Advance Captor 4300 Quick Start Manual

Also see for Captor 4300: Mechanical repair service manual Instructions for use Quick start troubleshooting manual

Nilfisk-Advance Captor 4300 Quick Start Manual Manual pdf 4 page image

22222 - FORM NO. 56043093 / Captor ™ 4300, 4800, 5400 / CR 1100, 1200, 1400TRANSPORTING THE MACHINETRANSPORTING THE MACHINETRANSPORTING THE MACHINETRANSPORTING THE MACHINETRANSPORTING THE MACHINECAUTION!CAUTION!CAUTION!CAUTION!CAUTION!Before transporting the machine on an open truck or trailer, make sure that . . .••••• All access doors are latched securely.••••• The machine is tied down securely - see tie-down locations (((((66666))))).••••• The machine parking brake is set.TOWING OR PUSHING A DISABLED MACHINETOWING OR PUSHING A DISABLED MACHINETOWING OR PUSHING A DISABLED MACHINETOWING OR PUSHING A DISABLED MACHINETOWING OR PUSHING A DISABLED MACHINECAUTION!CAUTION!CAUTION!CAUTION!CAUTION!The machine’s drive propelling pump is manufactured with a selectable tow valve. This valve prevents damage to the hydraulicsystem when the machine is being towed/pushed short distances without use of the engine.To access the valve, open the Engine Compartment Door (((((2222222222))))) and lift off the Right Engine Compartment Access Panel (((((3737373737))))). Locatethe valve as shown on the underside of the hydrostatic pump by reaching under the radiator. Turn the valve 90 degrees, thisdisengages the hydrostatic lock between the motor and pump.The hydrostatic pump can be damaged if the machine is towed with the valve in the normal working position (A)(A)(A)(A)(A). Reference theillustration below for the normal working setting (A)(A)(A)(A)(A) and the free wheeling towing setting (B)(B)(B)(B)(B). Note: If the tow valve is left in freewheeling (B)(B)(B)(B)(B) position the hydrostatic pump can’t drive the machine FWD or REV. No damage will result, just re-set valve to the normalworking setting (A)(A)(A)(A)(A). Tow or push machine no faster than a normal walking pace (2-3 miles per hour) and for short distances only.If the machine is to be moved long distances the drive wheel needs to be raised off the floor and placed on a suitable transport dolly.OTHER MANUALS AOTHER MANUALS AOTHER MANUALS AOTHER MANUALS AOTHER MANUALS AVVVVVAILABLEAILABLEAILABLEAILABLEAILABLEThe following manuals are available from the Nilfisk-Advance Literature Service Department, for your Rider Scrubber/Sweeper:••••• Parts List - Form Numbers 56042440 (all systems except hydraulic)56042445 (hydraulic system)••••• Operation Manual - Form Numbers 56041546 (Danish, Norwegian, Swedish, Finnish)56041547 (English, German, French, Netherlands)56041548 (Spanish, Portuguese, Italian, Greek)• Mechanical Repair Service Manual 56043094BOTTOM VIEW OF HYDROSTBOTTOM VIEW OF HYDROSTBOTTOM VIEW OF HYDROSTBOTTOM VIEW OF HYDROSTBOTTOM VIEW OF HYDROSTAAAAATIC PUMPTIC PUMPTIC PUMPTIC PUMPTIC PUMPGENERAL INFORMAGENERAL INFORMAGENERAL INFORMAGENERAL INFORMAGENERAL INFORMATIONTIONTIONTIONTION