Nilfisk-Advance Captor 4300 Quick Start Manual

Also see for Captor 4300: Mechanical repair service manual Instructions for use Quick start troubleshooting manual

Nilfisk-Advance Captor 4300 Quick Start Manual Manual pdf 8 page image

66666 - FORM NO. 56043093 / Captor ™ 4300, 4800, 5400 / CR 1100, 1200, 1400MAINTENANCE SCHEDULEMAINTENANCE SCHEDULEMAINTENANCE SCHEDULEMAINTENANCE SCHEDULEMAINTENANCE SCHEDULEMaintenance intervals given are for average operating conditions. Machines used in severe operational environments may requireservice more often.MAINTENANCE ITEMMAINTENANCE ITEMMAINTENANCE ITEMMAINTENANCE ITEMMAINTENANCE ITEM PERFORM DAILYPERFORM DAILYPERFORM DAILYPERFORM DAILYPERFORM DAILYPerform the “After Use” maintenance steps XCheck parking brake XCheck engine oil X*Clean main and side brooms XCheck filter indicator and lights (hyd & air) XCheck engine coolant level XCheck hydraulic oil level XMAINTENANCE ITEMMAINTENANCE ITEMMAINTENANCE ITEMMAINTENANCE ITEMMAINTENANCE ITEM 15 hrs.15 hrs.15 hrs.15 hrs.15 hrs. 30 hrs.30 hrs.30 hrs.30 hrs.30 hrs. 150 hrs.150 hrs.150 hrs.150 hrs.150 hrs. 300 hrs.300 hrs.300 hrs.300 hrs.300 hrs. 500 hrs.500 hrs.500 hrs.500 hrs.500 hrs. 1000 hrs.1000 hrs.1000 hrs.1000 hrs.1000 hrs.*Rotate main broom XClean solution filter X*Inspect/adjust brooms X*Clean hopper filter X X X*Inspect broom housing skirts X*Inspect hopper seals XClean radiator and oil cooler XPerform engine maintenance X*Inspect and grease steering rack XChange the hydraulic “charge” oil filter XChange reservoir hydraulic oil and filter XFlush the radiator XEngine fuel filter(s) gas or propane X*See the Mechanical Repair Service Manual and Operator Manual for detailed maintenance information of systems listed.• Sweeping• Hopper• Steering• Dust control• SqueegeeWARNING!WARNING!WARNING!WARNING!WARNING!Turn the key switch off, set the parking brake and disconnect the battery before servicing the machine.AFTER USEAFTER USEAFTER USEAFTER USEAFTER USE11111 Raise the squeegee, the scrub brushes, and the brooms.22222 Shake the dust control filter and empty the hopper.33333 Drain and flush the recovery tank.44444 Flush the vacuum hose and squeegee by opening the recovery tank lid and running water down the pickup tube on the right sideof the tank. SERVICE NOTE:SERVICE NOTE:SERVICE NOTE:SERVICE NOTE:SERVICE NOTE: Tip the recovery tank out and check the squeegee hose elbow below the tank to make sure it hasflushed out completely.55555 Remove and clean the squeegee tool (adjust as needed*).66666 Remove and clean the scrub brushes. Rotate the scrub brushes.77777 Wipe the machine with a damp cloth.88888 Perform all required maintenance before storage.99999 Move the machine to a clean, dry storage area.1010101010 Store the machine with the brooms, the squeegee and the scrub brushes in the UP position, and the tank covers open so thatthe tanks can air out.LUBRICALUBRICALUBRICALUBRICALUBRICATING THE MACHINETING THE MACHINETING THE MACHINETING THE MACHINETING THE MACHINESteering RackSteering RackSteering RackSteering RackSteering RackOnce every 150 hours pump a small amount of grease onto the steering rack and pinion components.Also every 150 hours apply light machine oil to maintain free movement of all general pivot points. Example the seat, and broom doorhinges etc. Broom, squeegee and hopper pivots use composite bearings lubrication is not required.MAINTENANCEMAINTENANCEMAINTENANCEMAINTENANCEMAINTENANCE