Nilfisk-Advance Convertamatic 24 Instructions For Use Manual

Also see for BA 625: Service manual Instructions for use

Contents

Nilfisk-Advance Convertamatic 24 Instructions For Use Manual Manual pdf 10 page image

A-10 / ENGLISHA-10 - FORM NO. - 56041596 - Convertamatic ™ 24, 26, 28, 32 / BA 625, 725, 825INSTALLING THE BRUSHES (DISC SYSTEM)INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)CAUTION!Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.1 Make sure the Brush Deck is in the RAISED position.Make sure the Key Switch (A) is off (O).2 See Figure 3. To access the brushes loosen theblack knobs (one on each side) on top of the idlerassemblies (24) and remove the idler assemblies.Slide the brush into the housing, lift slightly, push andturn until it seats. Re-install the idler assemblies.CAUTION!Turn the key switch off (O) and remove the key,before changing the brushes, and beforeopening any access panels.1 Make sure the Brush Deck (7) is in the RAISEDposition. Make sure the Key Switch (A) is off (O).2 If using pads, install the pads on the pad holders.3 See Figure 2. To mount the Brushes (AA) (orpad holders) align the Lugs (BB) on the brushwith the holes on the mounting plate and turnto lock in place (turn the outside edge of brushtowards the rear of machine as shown (CC)).FIGURE 2revised 1/07FIGURE 3