Nilfisk-Advance SC3500 Instructions For Use Manual

Also see for SC3500: Quick start guide Quick start guide

Nilfisk-Advance SC3500 Instructions For Use Manual Manual pdf 13 page image

USER MANUAL ENGLISH12Figure 6BATTERY MODE SET UP METHOD OF THECHARGERDo not to set charger unless you haveprofessional training1. Turn off the machine and disassemble the control cover(A as Figure 6) from the machine. Then pry open thelabel on the charger cover (B as Figure 6). you will findthe 2 sets of dipswitches (SW1 and SW2) in the charger.2. Only the set of dipswitch SW1 (the one on the left side)has effect on charging curve selection accordingly to thetable below.DP1 DP2 CHARGING CURVEON OFF IUIa-ACD for Lead-acid (Wet) batteriesOFF OFF IUIa-GEL for Gel batteries of Exide-SonnenscheinOFF ON IUU0-GEL for HAZE Gel and AGM batteries of other manufacturersON ON IUIUa-AGM for Discover AGM batteriesEMERGENCY BRAKINGIf there is any emergency during machine operating, press theemergency switch (A, Figure 6), then all functions of machine willstop, no display on control panel (B, Figure 6)BRUSH/PAD INSTALLATION AND UNINSTALLATIONNOTEInstall suitable brush (A, Figure 8) or Pad (B andC, Figure 8) according to the type of floor to becleaned.CAUTIONBefore installation or uninstallation of brush orpad, make sure all the switches on machine are inoff position and lifting up the squeegee from thefloor. The operator must be equipped with suitablepersonnel protection devices such as gloves toreduce the risk of accidents. Proceed as following:1. Turn off the machine and lift up the brushes (9 as figure 1) fromthe floor.2. Put the brush/pad holder on the floor under the brush hub andalign their center, then rotary the brush/pad holder in thedirection (D as Figure 8) show to install it manually.3. Press One-Start button (38 as Figure 2) on control panel, lift thebrushes (9 as Figure 2) up from the floor, then press brushrelease button (40 as Figure 2) to release brushes automatically.Rotary in the opposite direction (D as Figure 7) can manuallydisassemble the brush/pad holder.Figure 7BAADCBFigure 8BDP1 SW 1ADP2ONOFFONOFF