Nilfisk-Advance SC3500 Instructions For Use Manual

Also see for SC3500: Quick start guide Quick start guide

Nilfisk-Advance SC3500 Instructions For Use Manual Manual pdf 23 page image

USER MANUAL ENGLISH22SQUEEGEE BLADE CHECK AND REPLACEMENT1. Clean the steel or the aluminum squeegee, as shown in theprevious paragraph.2. Check that the edges (E, Figure 23) of the front blade (C) andthe edges (F) of the rear blade (D) lay down on the same level,along with their length; if necessary adjust their heightaccording to the following procedure:x Remove the tie rod (G), disengage the fasteners (M) andadjust the rear blade (D), then engage the fasteners (M) andinstall the tie rod (G).x Loosen the knobs (I) and adjust the front blade (C), thentighten the knobs.3. Check the front blade (C) and rear blade (D) for wear, cutsand tears; if necessary replace them according to thefollowing procedure. Check that the front corner (J) of therear blade (D) is not worn; if necessary overturn the blade toreplace the worn corner with an integral one. If the othercorners are worn too, replace the blade according to thefollowing procedure:x Remove the tie rod (G), disengage the fastener (M) andremove the retaining strip (K), then replace/overturn the rearblade (D). Assemble the blade in the reverse order ofdisassembly.x Unscrew the knobs (I) and remove the retaining strip (L), thenreplace front blade (C). Assemble the blade in the reserveorder of disassembly. After the blade replacement (oroverturning), adjust the height as shown in the previous step.4. Connect the vacuum hose (A, Figure 24) to the squeegee.5. Install the squeegee (B Figure 24) and screw down the knows(C Figure 24).6. If necessary, adjust the squeegee balance adjusting knob (DFigure 24).BCCA DFigure 23Figure 24DLIMDMBKCIE FAGAJCI