Nilfisk-Advance Sweeper SR 1700D 2W D User Manual

Contents

Nilfisk-Advance Sweeper SR 1700D 2W D User Manual Manual pdf 47 page image

USER MANUAL33014815(1)2005-07 A 9Joystick(See Fig. J)The joystick is used for the following functions (all of thefunctions must be carried out with the safety switch pressed):– Hopper lifting (1, Fig. J);– Filter shaker (2, Fig. J);– Skirt opening (3, Fig. J);– Side broom lowering (4, Fig. J);– Side broom rotation (5, Fig. J);– Main broom lowering (6, Fig. J);– Main broom rotation (7, Fig. J);– Skirt closing (8, Fig. J);– Hopper lowering (9, Fig. J);– Main broom rotation (10, Fig. J);– Main broom lowering (11, Fig. J);– Suction fan stop (12, Fig. J);– Main broom rotation stop (13, Fig. J);– Side broom rotation stop (14, Fig. J);– Main broom lifting (15, Fig. J);– Side broom lifting (16, Fig. J);– Safety switch.INSTRUCTIONS FOR USEStart– Before starting the machine, make sure the parkingbrake (5, Fig. H) is engaged.– Insert the ignition key in the ignition switch.– Turn the accelerator lever (4, Fig. H) to idle.– Turn clockwise to the first position.Battery charge, oil pressure and glow plug pre-heatingwarning lights should be on.– Turn the ignition key clockwise until “Engine start”position is reached. When the engine is on, release theignition key which will automatically return to the firstposition.Switching offTurn the ignition key counterclockwise to “0” position and thenremove it. Pull the parking brake lever.Hand pump(See Fig. K)– Install the lever (2, Fig. K) in the pump.– Make sure that the slider is in a position that allows thecab to be lifted.– Pump to lift the cab.– To lower the cab, change the position of the slider (3,Fig. K).MACHINE USEWaste collection– Turn the accelerator lever to the maximum speedposition.– Operate the fan by pressing the push-button.– Main broom lowering, fan and main broom start, skirtopening: press the push-button and release. The mainbroom lowers and starts rotating. The suction fan startsworking at the same time.– Main broom and right side (left side optional) broomlowering and start: press the push-button, the broomslower and start rotating. Hold the push-button presseduntil the ideal adhesion for the type of cleaning to becarried out is reached.– In case of wet surface, turn off the fan.– The operating speed recommended for the sweeper,adjusted by means of the pedal, ranges from 1 to 8 km/h,depending on the amount of waste to be collected.During the collection phase, the waste should be compactedin order to maximize the load collected:– Stop the sweeper.– Close the skirt.– Re-open the skirt and re-start the sweeper.NOTEMachines with the EC marking are providedwith safety devices should the operator leavethe driver’s seat.The machine cannot be started unless theoperator is sitting in position.NOTEBefore trying to start the machine again, turnthe ignition key back to “0” position.As soon as the machine has been started,check the battery charge, oil pressure andpre-heating warning lights are off.WARNING!Use the hand pump (1, Fig. K) to lift the cab. Donot lift the cab with the hopper in the liftedposition.NOTEAfter lowering the cab, maintain the slider inthe middle position.