Nilfisk-Advance Warrior ST Service Manual

Also see for Warrior AXP: Service manual Instructions for use Sevice manual

Contents

Recovery System 48Service Manual – Warrior ST, AXP, EcoFlexRemoval and InstallationVacuum Motor1 Turn off the key and disconnect the batteries.2 Drain the recovery tank and move it to the openposition3 Disconnect the vacuum motor cable connector.4. Remove the screw and washer from the dischargehose clamp (23)5. Remove the four screws (20) and washers (19)that secure the vacuum motor housing (18) tothe recovery tank, and remove the housing. Becareful not to let the motor fall, as the housing iswhat holds it in placeCableConnector2223186 Remove the vacuum motor (15) and discharge hose (22). Take care not to lose the three vibrationmounts (16)7. If necessary, remove the cable tie (21) that secures the discharge hose to the motor outlet8 Inspect the main vacuum gasket (14) for damage and compressibility, and replace if necessary. Leaks inthis gasket will reduce recovery system suction.9. Inspect the motor ventilation gasket (17) for damage and compressibility. This gasket holds the vacuummotor assembly in position against the recovery tank.10 Make service repairs to the vacuum motor as needed, and re-install by reversing the procedure steps.Recovery Tankin Open Position141516 171819 20222321