161.877.646. 5288Fig. 14Fig. 15Assembly and Use for the Food Processor BowlASSEMBLYWARNING: Never leave the appliance unattended while in use.Fig. 16aFig. 16bIMPORTANT: Make sure that the motor base isplugged in for use.1 Place the motor base on a clean, dry, level surfacesuch as a counter or table top.2 Align and lower the Bowl onto the motor base.(Fig. 14) Handle should be aligned slightly to theright of the “LOCK” symbol on the motor base.3 Rotate the bowl clockwise as far as it will go tolock in place. (Fig. 15)4 The bowl can be placed on the motor base twoways; the handle can be on the front right corner orthe front left corner. (Fig. 16a, Fig. 16b)5 Holding the desired blade by the top of the shaft,place it onto the drive gear inside the bowl. Ensurethat the attachment is seated properly and isstanding upright. (Fig. 17)NOTE: The blade will fit loosely on the star-shapedpost.6 Add the ingredients to the bowl, making sure thatthey do not exceed the highest measured markingline on the side of the bowl.7 Holding the lid from the feed chute, place it on topof the bowl and turn clockwise aligning the arrow( ) located on the lid with the arrow ( ) locatedon the bowl’s handle. (Fig. 18)8 Plug the power cord into the electrical outlet andpress up on the power toggle ( ) to turn the power“On”.NOTE: The 64 oz. bowl is not intended forblending drinks. Do not overfill.NOTE: To add liquids duringprocessing, remove the foodpusher from the feed chute todrizzle in liquids. Do not removethe lid while in use.TIP: Turn the unit down to thelowest setting before addingadditional liquids.Dough &ProcessingDough &ProcessingFig. 17Fig. 18////