Nobel FCD 05 Instruction Manual
                                 | |
Contents
| 
INSTRUCTIONS MANUAL AUTOMATIC FILTERSFCD-FACD-FFD /DT /DP /DT-DUAL /DP-DUALs.r.l.Milano - ITALY Page 17 of 23 fcd-dp_mi-r4.doc – r.47.3. How to set day and time of regenerationThe days of the week can be set one by one; they appear on the display in the weekly row: itis possible to select (visualized the initial letter of the day) or not (visualized the symbol -).The row and explanation of the symbols that appear on the display are :M / - T / - W / - T / - F / - S / - S / -MondayTuesdayWednesdayThursdayFridaySaturdaySundayThe available digits to set the time are between 00:00 and 23:59; the symbol --:-- indicatenot any ON and/or not any OFF.The regeneration starts at the time set on the line ON.The time on the line OFF MUST BE NECESSARILY SET one minute later than the timeon the line ON.The programmer allows to set up to 3 regeneration per day (B3-1, B3-2, B3-3).Proceed as follows to modify :1. push the button ESC2. push several times the button until the pointer > points "set param"3. push the button OK .4. push several times the button until the display shows the parameter where to make themodification (B3 - 1 or other)5. push the button OK , the blinking cursor will take place on the line of the days (D)6. by pushing the button the cursor moves on the positions correspondent to the days ofthe week7. push the button to enable/disable8. by pushing the button the cursor moves on the several digits of the hours (lines ON andOFF)9. when the cursor blinks on the digit to modify, push several times the until the desirednumber appears10. repeat the same operations with other digits, whether required.11. push the button OK to confirm the modifications12. push the button to visualize other parameters which must be modified, and operate asexplained at above points 5 ÷11, or push the button ESC to leave the modification menu13. push the button ESC to go back to visualization of service.WARNING : parameter B3-4 is concerning the pulse function of the parametersB3-1, B3-2 and B3-3; for a proper working of the whole system, thisparameter must be necessarily set on OFF position.7.4. How to set time of phases, delay, pressure drop valueProceed as follows to modify :1. push the button ESC2. push several times the button until the pointed > points "set param"3. push the button OK .4. push several times the button until the parameter to modify is shown (B1 or other)5. push the button OK . |
Related manuals for Nobel FACD 05
manualsdatabase
Your AI-powered manual search engine