Install a A-020W-A367368 ISAM CPE A-020W-A Product Guide3FE-47511-AAAA-TCZZA Issue: 015 Connect the power cable to the power connector.6 Power up the unit by using the On/Off power switch.7 Verify the LEDs and voltage status.8 Activate and test the services.9 If necessary, reset the A-020W-A CPE.i Locate the Reset button as shown in Figure 8.ii Insert the end of a straightened paper clip or other narrow object into the hole in theReset button to reset the device.10 STOP. This procedure is complete.Note — Observe the following:• Units must be powered by a Listed or CE approved and markedlimited power source power supply with a minimum output rate of12 V dc, 1 A. The polarity of the power adapter plug must match theA-020W-A CPE.Note — Resetting the device will return all settings to factory defaultvalues; any configuration customization will be lost.
