Nokia 7368 Product Manual

Also see for 7368: Product guide Product guide Product guide Product guide

Contents

Nokia 7368 Product Manual Manual pdf 49 page image

7368 ISAM CPE A-240Z-A Product Guide A-240Z-A unit data sheetIssue: 01 3FE-46615-AAAA-TCZZA 495.8.4 FCC statementThis equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This equipment generates, uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.• Consult the dealer or an experienced radio/TV technician for help.5.8.5 FCC Radiation Exposure StatementThis device complies with FCC radiation exposure limits set forth for an uncontrolledenvironment and it also complies with Part 15 of the FCC RF Rules. This equipmentmust be installed and operated in accordance with provided instructions and theantenna(s) used for this transmitter must be installed to provide a separationdistance of at least 20 cm from all persons and must not be co-located or operatingin conjunction with any other antenna or transmitter. End-users and installers mustbe provided with antenna installation instructions and consider removing theno-collocation statement.This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:1 this device may not cause harmful interference, and2 this device must accept any interference received, including interference thatmay cause undesired operation.Caution — Any changes or modifications not expresslyapproved by the party responsible for compliance could voidthe user's authority to operate the equipment.5.9 A-240Z-A special considerationsThis section describes the special considerations for A-240Z-A CPEs.