Phone IP address (for IPv4 only) — Enter the IP address of your device.DNS addresses — Enter the IP addresses of the primary and secondary DNS servers,if required by your service provider. To obtain these addresses, contact your internetservice provider.Proxy server address — Enter the address of the proxy server.Proxy port number — Enter the port number of the proxy server.WLAN access point settingsSelect Menu > Settings and Connectivity > Destinations > Access point, and followthe instructions.Edit a wireless LAN (WLAN) access pointSelect an access point group and access point marked with . Follow the instructionsfrom your WLAN service provider.Select from the following:WLAN network name — Select Enter manually or Search for networks. If you selectan existing network, the WLAN network mode and WLAN security mode aredetermined by the settings of its access point device.Network status — Define whether the network name is displayed.WLAN network mode — Select Ad-hoc to create an ad hoc network and to allowdevices to send and receive data directly; a WLAN access point device is not needed.In an ad hoc network, all devices must use the same WLAN network name.WLAN security mode — Select the encryption used: WEP, 802.1x, orWPA/WPA2(802.1x and WPA/WPA2 are not available for ad hoc networks). If you select Opennetwork, no encryption is used. The WEP, 802.1x and WPA functions can be used onlyif the network supports them.Homepage — Enter the web address of the starting page.Use access point — Set the device to create a connection using this access pointautomatically or after confirmation.The available options may vary.View your active data connectionsSelect Menu > Settings and Connectivity > Connection mgr..In the active data connections view, you can see your data connections:data callspacket data connectionsWLAN connectionsConnectivity 85