SNMP DescriptionNokia IP40 User Guide 1053. Specify the System Location, such as IP40 Lab/California.4. Mention the System Contact, such as contact person and phone number.5. Mention the SNMP port. This number defines the port where the SNMP daemon will run.6. Define the SNMP traps which need to be generated:! Startup — If you check this box, SNMP trap will be generated and reported to theSNMP Manager when the SNMP daemon restarts.! Link up/down — If you check this box, SNMP trap will be generated and reported to theSNMP Manager when the connection to WAN or LAN is temporarily unavailable orbecomes available.! User Login — If you check this box, SNMP trap will be generated and reported to theSNMP manager when SNMP access is made with an incorrect community name.7. Specify the IP address where the SNMP Manager is running, so that traps that are generatedcan be sent to the correct IP address. The default port number is 162.NoteYou need to set the trapPduAgent to a specified IP address from the command prompt so asto view the IP address of the device from where a trap is generated. Use the command ‘setsnmp trappduAgent ip_address’ from the IP40 CLI for setting the trapPduAgent. You cannotset the trapPduAgent from the IP40 GUI portal. Refer to the IP40 CLI Reference Guide formore information.Configuring SNMP Parameters from the Command-line InterfaceYou can use the SNMP CLI commands to set and view parameters for SNMP.Setting SNMP Parameters from the command-line interfaceYou can set the SNMP parameters from CLI using the set command.
