Firmware Upgrade in Failsafe ModeNokia IP40 User Guide 119Firmware Upgrade in Failsafe ModeWhen the IP40 goes to failsafe mode, you can use the following procedure for upgrading thefirmware. Refer to “Upgrading the firmware through Out of Band Dial-in (Failsafe Mode)” onpage 110 for information on upgrading firmware in failsafe mode through OOB.To upgrade the firmware using Console and LAN1. Connect to the console. Use “admin” and “password” as the default user name andpassword.Welcome to IP40 (failsafe)login: adminpassword:Device is running in failsafe mode. You must upgrade the deviceimmediately.2. Specify the LAN IP address and Netmask when prompted.3. The device waits for the FTP client to upload the firmware once the LAN interface isconfigured.Device is waiting for ftp client to upload the firmware.You must close ftp session using ‘quit’ command after uploadingfirmware.Press Ctrl+C to Cancel.4. FTP to the configured LAN IP address and upload the firmware.5. The device requests your confirmation for firmware upgrade after successful firmwareupload. Press ‘y’ to confirm.6. The device displays the appropriate message depending on success or failure of firmwareupgrade.Installing Your Product KeyYour IP40 is identified by the product key that is obtained when you purchase the device. Youcan purchase and upgrade to any of the other versions of the IP40.To install a product key1. In the Navigation Bar click Setup.2. Click the Firmware tab.The Firmware page appears
