GB 25Time Adjustment: Adjust the clock in steps of ± 1/2 hour.Display volume indicator: Possibility to turn on/off the VolumeIndicator on screen.LNB Adjustment: If the cable up to the LNB is very long it mightbe necessary to increase the Voltage by 0,5 V.Symbols on the Mediamaster displayNo TS No Transport Stream= No signal.Channel name.Signal indicator.A square means full signal.? No function.Err Error message.UPGRADEThe Mediamaster is busydownloading new software.Do not make any adjust-ments during this opera-tion!Automatic InstallationWill start the Installation procedure from the “Welcome Menu”.When you press OK in the “Welcome Menu” again, be awareof the fact, that all previous channels and settings will beerased!To exit the ”Welcome Menu” without erase, press EXIT.Receiver upgradeIf your Service Provider has a new software version available forthe Mediamaster, you will be recommended to download it.To do that, select the line “Receiver upgrade” and follow the in-structions.If no software is available yet, you will get the message“No new software available”.Please note, that during a download procedure you must NOTperform any other adjustments or settings on the Mediamaster!IMPORTANT! Updating via satellite may take up to one hour.DO NOT turn off the Mediamaster or disconnect the dish/LNB cable during this procedure!!Telephone Modem SettingsIf you are connected to the Telephone net via the built in Modem,make the necessary settings from this menu.Country: Select the country where you are.Pulse/Tone: Select the alternative that is valid for your system.Prefix digit: If the connection goes through a terminal, select thedigit that opens the line.