Nokia N91 - Smartphone 30 MB User Manual

Also see for N91: User guide User guide User guide Owner's manual User guide

Contents

Nokia N91 - Smartphone 30 MB User Manual Manual pdf 103 page image

Tools103Copyright © 2005 Nokia. All rights reserved.WLAN netw. mode—Select Ad-hoc to create an ad-hocnetwork and to allow devices to send and receive datadirectly; a wireless LAN access point device is not needed.WLAN security mode—Select the encryption used: WEP,802.1x (not for ad hoc networks), or WPA/WPA2. If youselect Open network, no encryption is used. The WEP,802.1x, and WPA functions can be used only if the networksupports them.WLAN security sett.—Enter the settings for the selectedsecurity mode:Security settings for WEP:Wep key in use—Select the WEP key number. You cancreate up to four WEP keys. The same settings must beentered on the wireless LAN access point device.Authentication type—Select Open or Shared for theauthentication type between your device and the wirelessLAN access point device.WEP key settings—Enter WEP encryption (length of thekey), WEP key format (ASCII or Hexadecimal), and WEPkey (the WEP key data in the selected format).Security settings for 802.1x and WPA/WPA2:WPA mode—Select the means of authentication: EAP touse an extensible authentication protocol (EAP) plug-in, orPre-shared key to use a password. Complete theappropriate settings:EAP plug-in settings (only for EAP)—Enter the settings asyour service provider instructs.Pre-shared key (only for Pre-shared key)—Enter apassword. The same password must be entered on thewireless LAN access point device.TKIP encryption—Select whether Temporal Key IntegrityProtocol (TKIP) is used.Homepage—Define a home page.Select Options > Advanced settings and from thefollowing:IPv4 settings: Phone IP address (the IP address of yourdevice), Subnet mask (the subnet IP address), Defaultgateway (the gateway), and DNS address—enter the IPaddresses of the primary and secondary DNS server.Contact your Internet service provider for these addresses.IPv6 settings > DNS address—Select Automatic, Well-known, or User defined.Ad-hoc channel (only for Ad-hoc)—To enter a channelnumber (1-11) manually, select User defined.Proxy serv. address—Enter the address for the proxyserver.Proxy port number—Enter the proxy port number.