Nokia NBB5005000 - IP VPN 5i Installation Manual
                                                | |
Contents
| 
2 Installing a Nokia 5i and 10i Gateway32 Nokia 5i and 10i Installation GuideConnecting Network InterfacesNokia IP VPN gateways support three built-in dual-mode 10-Mbps and 100-Mbps ports.Connecting to Ethernet PortsYou can connect one network interface to the network to use as the Nokia IPVPN Gateway interface. You configure this interface during the systemstartup procedure, which is described in the Performing the Initial GatewayConfiguration section of the Nokia IP VPN Installation Guide.You can also connect the remaining LAN and WAN interface cables at thispoint, although you are not required to do so.After the power is turned on, the Ethernet link LEDs on the gateway and onremote equipment illuminate to indicate the connection. As data istransmitted, the activity LEDs on the gateway illuminate.This section describes how to connect the Ethernet network cables to yourgateway.1 Off: No link.Steady green: Interface connected and autonegotiated at 10 Mbpsand 100 Mbps.2 Off: No link.Steady green: Interface connected and autonegotiated at 10 Mbpsand 100 Mbps.3 Off: No link.Steady green: Interface connected and autonegotiated at 10 Mbpsand 100 Mbps.Table 5 System Status LEDs for the Nokia 5i and Nokia 10i (continued)LED Description |
Related manuals for Nokia 10i
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine