Nolangroup N-Com B901 S Series User Instructions And Safety

Nolangroup N-Com B901 S Series User Instructions And Safety Manual pdf 10 page image

EN10• Before you place the speaker in its housing, apply the Velcro pad to the polystyrene cheek pad(right side).• Position the loudspeaker in its housing obtained in the polystyrene cheek pad (right side).• Replace the polystyrene cheek pad (right side), positioning the cable in the groove you see in thecheek pad.ONLY FOR FULL-FACE HELMETS: Insert the chin guard (microphone side), gently placing themicrophone in its housing. Then press down on the red tab until the chin guard is locked in place onthe helmet.• Position the comfort padding in its housing (see specific instructions provided in the helmet usermanual), hooking the neck roll.• Position both the comfort cheek pads in their housing (see specific instructions provided in thehelmet user manual) making sure that all the press-studs click.Note: Carefully check the proper final positioning of the cheek pad, pulling the chinstrap toward theinside of the helmet and testing the press-studs.Caution: Make sure that there are no cables sticking out of the helmet and that the loudspeakers arein their housing.Caution: Always verify the proper length of the chinstrap and adjust it as necessary, once againreferring to the specific helmet instructions.• Position the e-box in the relevant housing. First insert the front part, then press down on the e-box until both hooks fully click.Warning: Do not leave the helmet exposed to atmospheric agents without the e-box or theprotection plate provided with the helmet.3.3. Removing the system• Remove the protection plate, then, looking at the helmet from the outside, release the connectorby acting on the fastening clasp as illustrated in the figure.• After releasing the connector from the shell, also remove the right part by releasing the batteryholder.• Now remove the entire system from the helmet.Note: Before using the N-Com device for the first time, recharge the battery completely for at least 10hours. To obtain best performances from the battery, it is recommended to completely recharge thebattery the first few times. Afterwards, you can recharge the battery for shorter periods. Wheneverpossible, it is best to recharge the battery completely.Fig. 19• To remove the system from the helmet, remove theearphone and the comfort cheek pads as shown in theassembly operations. Then remove the polystyrene cheekpads.• To remove the e-box, press the two sliding hooks at thesame time until the e-box comes out.