Norac UC4 Total Control Operator's Manual

Also see for UC4 Total Control: Installation manual Installation manual Installation manual Installation manual Installation manual

Norac UC4 Total Control Operator's Manual Manual pdf 25 page image

235.4.2 Main Menu OverviewNavigating past the end of the menu will return the panel to the operating screenMore ?More ?More ?More ? Press YES (Auto) to edit or view more sensor settings.To locate more information on this menu item, refer to Section 5.4.3Roll 0.5Roll 0.5Roll 0.5Roll 0.5 Displays reading of the main roll sensor.Depending on sprayer type this menu item may not be displayed.25 2925 2925 2925 29 Displays readings from optional boom sensors (left inner andright inner). This menu item may not be displayed.31 31 3231 31 3231 31 3231 31 32Displays the current boom heights, in inches, from left toright. The heights are adjusted for the offset between thesensor and nozzles. If any sensor errors are detected the type oferror will be displayed here.30 MM 3530 MM 3530 MM 3530 MM 35Sensor DisplayMenu↑↑↑↑SENSOR DISPLAY /SETUP Switch↓↓↓↓SetupMenuThe operating screen is normally displayed.While at other menu items, if no switch hasbeen pressed for 30 seconds the panel willrevert to this screen. Also, from any screen, ifyou press and hold the Setup switch for twoseconds the panel will return to this screen.To navigate to the other screens in this tablepush the SENSOR DISPLAY/SETUP switchin the indicated directionSensi 5Sensi 5Sensi 5Sensi 5Displays the current control sensitivity setting. A highernumber means a higher sensitivity resulting in more controlactions and quicker response. A lower number will tendstabilize the boom and make it less active. Range is from 1 to10.Soil ONSoil ONSoil ONSoil ONOrCrop ONCrop ONCrop ONCrop ON Use the +/- switch to set the sensor target to Soil or Crop.ReTune?ReTune?ReTune?ReTune?Use the Auto (YES) switch to initiate the automatic hydraulicevaluation of your system. The system will optimize yoursystem for the best performance possible. The evaluation willtake from one to three minutes.For a description of the ReTune menu item refer to Section 6.3More ?More ?More ?More ? Press YES (Auto) to edit or view more control settingsTo locate more information on this menu item, refer to Section 5.4.3 .Navigating past the end of the menu will return the panel to the operating screen