Norac UC4 Total Control Operator's Manual

Also see for UC4 Total Control: Installation manual Installation manual Installation manual Installation manual Installation manual

Norac UC4 Total Control Operator's Manual Manual pdf 9 page image

7Figure 4 – Roll Control of the Center Frame4.3 Mounting the Center SensorSpecial attention is necessary when mounting the center roll sensor.Mounting the center roll sensor directly behind a sprayer tire may impairmain lift control when operating in CROP MODE. Height readings fromcrop that is flattened by the sprayer wheel does not provide an accuratemeasurement of canopy height, resulting in poor performance. Moving theroll (center) sensor to a different location away from the wheel is the easiestsolution, however this is not always practical. Other options are explainedbelow.4.3.1 Turning the Center (Main lift Section) OffThis workaround will disable the center section’s AUTOMATIC control;however, manual control will still be possible. Sprayer wings will still becontrolled automatically. Carry out the following procedure using the UC4control panel:1. Make sure you are in manual mode, at the operating screen.↓↓↓↓35 MM 3535 MM 3535 MM 3535 MM 352. Navigate to the "More ?" item in the SETUP menu. Press AUTO (YES).3. Navigate to the "Main ?" item in the SETUP menu. Press AUTO (YES).4. At the "Main On" prompt, toggle the +/- switch to change to “Main Off”.↓↓↓↓Main OffMain OffMain OffMain Off5. Press and hold SETUP for two seconds to return to the operationalscreen.