MODEL 78500 2,000 LBS. CAPACITY BATTERY DOLLYSETUP • OPERATING • MAINTENANCE INSTRUCTIONSPROFESSIONAL LIFTING EQUIPMENT®BEFORE USING THIS BATTERY DOLLY, READ THIS MANUALCOMPLETELY AND THOROUGHLY, UNDERSTAND ITSOPERATING PROCEDURES, SAFETY WARNINGS ANDMAINTENANCE REQUIREMENTS. FAILURE TO DO SOCOULD CAUSE ACCIDENTS RESULTING IN SERIOUS ORFATAL PERSONAL INJURY AND/OR PROPERTY DAMAGE.The use of battery dollies is subject to certain hazards that cannotbe prevented by mechanical means, but only by the exercise ofintelligence, care, and common sense. It is therefore essential tohave owners and personnel involved in the use and operation ofequipment who are careful, competent, trained, and qualified inthe safe operation of the equipment and its proper use. Examplesof hazards are dropping, tipping, or slipping of motor vehicles ortheir components caused primarily by improperly securing loads,overloading, off-centered loads, use on other than hard levelsurfaces, and using equipment for a purpose for which it wasnot designed. It is the responsibility of the owner to make sureall personnel read this manual prior to using this device. It is alsothe responsibility of the device owner to keep this manual intactand in a convenient location for all to see and read. If the manualis lost or not legible, contact Norco Industries, Inc. for a freereplacement. If the operator is not fluent in English, the productand safety instructions shall be read to and discussed with theoperator in the operator’s native language by the purchaser/owneror his designee, making sure that the operator comprehends itscontents.WARRANTYThis battery dolly is covered by a Limited Lifetime Warranty. Fordetails see the back cover of Norco’s product catalog.IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATINGWARNING• Inspect dolly for mechanical fitness before using. Do not usethe dolly if it is damaged, altered, modified, in poor condition,worn out, or unstable due to loose or missing hardware orcomponents. Take corrective action before using the dolly.Replace rubber lift pads when necessary.• Make sure all nuts and bolts are tightened before using.• Position battery on dolly/dollies where weight distribution isequalized.• Never spread the width of the outriggers beyond the ends ofthe tie bar. All outriggers should be in full contact with the tiebar at all times.• Never adjust lift pads higher than five inches from the top of thesteel outriggers to the top of the rubber pads.• Use on a hard level concrete surface only.• Do not use beyond rated capacity.• Make sure setup is stable and secure before moving a batterysupported by dolly/dollies.• Do not position personal body under battery when placingbattery on dolly/dollies or when battery is supported by dolly/dollies.• No alterations should be made to this product.• Only attachments and/or adapters supplied by Norco shall beused.Note: Revision letters (A, B, C, D etc.) after model numbers have been omitted as they do not affect the setup,operating and maintenance instructions of a particular jack unless otherwise noted.OPERATING INSTRUCTIONS1. Set the height adjustment for all four extensionpad assemblies to the desired height.