16Inspect and tighten all parts of the stepper regularly.The stepper can be cleaned with a soft cloth and asmall amount of mild, non-abrasive detergent. Keepliquids away from the console.HOW TO ADJUST THE REED SWITCHFor the console to display correct feedback, the pedalsmust move at least five inches with each step. If theconsole displays incorrect feedback when the pedalsare moved five inches or more, the Reed Switch (56)should be adjusted.Remove the right Pedal Bracket (13) by removing thetwo M10 x 82mm Button Bolts (26) and the two M10Nylon Locknuts (not shown). Then, remove the two M4x 38mm Screws (64) and the three M4 x 25mm Screws(65). Carefully slide the Right Side Shield (8) off thestepper.Turn the Flywheel (46) until the Magnet (32) is alignedwith the Reed Switch (56) (refer to the inset drawing).Loosen the indicated Screw (52). Slide the ReedSwitch slightly closer to the Flywheel, and retightenthe Screw. Make sure that the Magnet will not hitthe Reed Switch when the Flywheel turns. Repeatuntil the console displays correct feedback.Carefully slide the Right Side Shield (8) back onto thestepper. Reattach the three M4 x 38mm Screws (64)and the two M4 x 25mm Screws (65). Reattach thePedal Bracket (13).HOW TO LEVEL THE STEPPERIf the stepper rocksslightly during use,turn one or both ofthe Feet (15) underthe Stabilizer (2) untilthe stepper is level.TROUBLESHOOTING AND MAINTENANCE52324615213646526856