NordicTrack VGR 850 User Manual

Also see for NTCCEL47300: User manual Manuel de l'utilisateur

Contents

Console

88. Find the Left Pedal (31), which has a ridge on theright side. Attach the Left Pedal to one of the PedalArms (12) with three M4 x 19mm Flange Screws(16) as shown.Repeat this step to attach the Right Pedal to theother Pedal Arm (not shown).8311216Ridge7. Connect the Extension Wire (2) to the correspondingwire on the Console (6).Next, connect the two Pulse Wires (15) to the tworemaining wires on the Console (6). Note: EitherPulse Wire can be attached to either wire on theConsole.Next, connect the ground wire to the indicated hole inthe Upright (3) with an M4 x 16mm Screw (34).Carefully feed the wires down into the Upright (3).Attach the Console Base (14) to the Upright with fourM4 x 16mm Screws (34). Be careful to avoid pinch-ing the wires.715614343432ConsoleWires34Ground Wire9. Identify the Left Handlebar (8) (there is an “L” stickeron the Left Handlebar). Apply a thin film of theincluded grease to the axle on the Left Handlebar.Make sure that there are two Pedal Arm Bushings(11) in each Pedal Arm (12).Slide a Handlebar Spacer (39) and the Pedal Arm(12) with the Left Pedal (31) onto the Left Handlebar(8) as shown. (Note: These parts fit tightly; it may behelpful to use the rubber mallet.) Next, tap a 3/4”Axle Cap (43) onto the Left Handlebar.Repeat this step to attach the other Pedal Arm (12) tothe Right Handlebar (62).8ApplyGrease621143121293931