Hardware Installation and Setup 3-7Part 1120130 2011 Nordson CorporationPump Drive Internal FilterThe AltaBlue melter is manufactured and shipped from the factory incompliance with CE regulations. If the pump drive internal filter, locatedinside each pump drive, is turned off, the melter will no longer beCE‐compliant.Figure 3-5 Location of the pump drive internal filter inside a pump driveOther ConsiderationsConsider the following additional factors when evaluating where to install themelter. The maximum distance between the melter and each applicator isdictated by the power requirement of each hose. Refer to Appendix A,Calculating Melter Power Requirements, for information about how todetermine the maximum allowable length. The operator must be able to accurately monitor and safely reach thetouch screen display. The operator must be able to safely observe the level of hot melt insidethe hopper/reservoir. The melter must be installed away from areas with strong drafts or wheresudden temperature changes occur. The melter must be installed where it will be in conformance with theventilation requirements specified in the Material Safety Data Sheet forthe hot melt being used. The melter should not be exposed to excessive vibration.
