Nordson CoolWave 2 Product Manual
Also see for CoolWave 2: Instruction sheetInstruction sheetInstruction sheet
                                                                                                                     | |
Contents
|
Installation 3-21Part 1089210A04 2010 Nordson CorporationConfiguration 2Configuration 1FunctionDisplayPCTL Power control algorithm Y = Enable Power ControlmodeN = Use current controlmode (default)If set to PCTL Y, the power control algorithm controls the total power output to reducethe variation of power over the life of the magnetron.PCTL N is the default and preferred method of control (current control).LAN Language in which faultsare displayedENG=English FR=FrenchIT=ItalianGE=GermanSP=SpanishUse this setting to choose the language faults will be displayed. English is the defaultlanguage.IDLE Enabling IDLE modeallows return to Lamp ONmode within 3 seconds(utilize the Standbycommand for activation).This is done by operatingthe lamp system at a lowpower, which is notcapable of curing withminimal heat on substrate.IDLE N=NoNot enabledIDLE Y=YesOperation of IDLE mode(local or remote) throughStandby control. SeeInstallation Section forproper sequence.VSPD Lampheads with aninternal blower mayincorporate variable speedcontrol to provideconsistent bulbtemperature.VSPD N=NoSet to N if lamphead is notequipped with internalblowerVSPD Y=YesEnables speed controlNote: Set only if internalblower lamphead inutilized.PWROFF POWER OFF No selection No selectionThis is a message instructing you to turn the power supply switch OFF to save yoursettings in flash memory. |
Related manuals for Nordson CoolWave 2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine