Installation 3-11Part 1603638-07 2016 Nordson CorporationSwitching I/O Inputs to SourcingInputs to I/O card are configured as sinking. 24 Vdc is applied to all HIterminals. To switch the inputs to sourcing:1. Disconnect all wires from the I/O card LO terminals, except terminal 24.Do not remove the blue and white wires from terminals 24 HI and 24 LO.2. Move the 6-pole jumpers from the HI terminals to the LO terminals.3. Install the red wire jumpers to connect all 6-pole jumpers together.4. Connect the red wire from the 25-conductor cable to terminal 1 LO.5. Connect the remaining wires to the HI terminals.6. At the PEJB, connect the red wire to the (−) terminal.Photoeye Junction BoxThe Photoeye Junction Box houses a 24Vdc power supply, terminal block,and scanner controllers. The box is typically mounted on the legs of thepart ID stand. The part ID cable and the encoder, conveyor interlock, andphotoeyes or discrete scanner controllers are wired directly to the terminalblock as shown in the junction box drawing.Power RequirementsThe junction box contains a 30 watt, 24−28 Vdc power supply. It requires120−240 Vac, 1 PH, 50/60 Hz, 2A.Conveyor Encoder ConnectionsBring the encoder cable into the junction box through a cord grip at one ofthe unused knockouts. Wire the cable to the encoder and the junction boxterminal strip as shown on the junction box drawing in Section 7.Photoeye ConnectionsConnect SO cable to the photoeyes and junction box terminal block asshown on the drawing. Route the cables into the junction box throughdust-tight cord grips.

Safety

Personal Safety

Grounding

Safety Labels

System Overview

Console and System Hardware and Software

Operator Interface

Dual Gun Cards

Internal and External Networks

Specifications

Special Conditions for Safe Use

Pedestal Dimensions

Console Dimensions

Approved Program and User Data Cards

Installation

System Connections

Interconnect Cables

CAN Network Address and Termination Settings

iFlow Module Switch Settings

Power Connections

Gun Current Path

ESD Ground Procedures and Equipment

Part ID Cable Connections

Switching I/O Inputs to Sourcing

Scanner Cable Connections

Analog Scanner Connections

Ethernet Network Connections

Gun Cable Connections

Pneumatic Connections

Program and User Data Cards

Touch Screen Calibration

Optional Air Conditioner Installation and Operation

Troubleshooting

CAN Network Errors

Gun Card Troubleshooting

Gun Card LEDs

iFlow Module Troubleshooting

iFlow Module Error Codes and Fault Codes

Ethernet Network Troubleshooting

In/Out Positioner Troubleshooting

Other In/Out Positioner Troubleshooting

Reciprocator Troubleshooting

Other Reciprocator Troubleshooting

Other Fault Messages and Conditions

Photoeye, Encoder, and Interlock Troubleshooting

Touch Screen Troubleshooting

Calibration with a Mouse

Touch Screen Failure

Repair

Flow Module Repair

Proportional Valve Replacement

Adding Guns

Ribbon Cable Connections

Touch Screen Replacement

Parts

Main/Auxiliary Console Parts

Pedestal Parts

IFlow Module Parts

Options

Photocell and Scanner Cables

Wiring Diagrams and Schematics

Nordson Encore iControl 2 Installation, Troubleshooting, Repair

Encore iControl 2