Safety1-8 1995 Nordson CorporationAll rights reservedIssued 11/95A1EN−03−[SF−LIQD]−3Do not operate a system that contains malfunctioning components. If acomponent malfunctions, turn the system OFF immediately. Disconnect and lock out electrical power. Close and lock outhydraulic and pneumatic shutoff valves and relieve pressures. Allow only qualified personnel to make repairs. Repair or replace themalfunctioning component according to instructions provided in itsmanual.Allow only qualified personnel to perform maintenance, troubleshooting,and repair tasks. Only persons who are properly trained and familiar withNordson equipment are permitted to service this equipment. Always wear appropriate protective clothing and use safety deviceswhen working on this equipment. Follow the recommended maintenance procedures in your equipmentmanuals. Do not service or adjust any equipment unless another person trainedin first aid and CPR is present. Disconnect, lock out, and tag electrical power at a disconnect orbreaker in the service line ahead of electrical equipment beforeservicing. Relieve air and fluid pressures before servicing equipment. Followthe specific instructions in this manual. Use only genuine Nordson replacement parts. Using unapprovedparts or making unapproved modifications to equipment may voidagency approvals and create safety hazards.WARNING: Note the flash point of the cleaning solvent used.Only use controlled methods and equipment, such astemperature-controlled or explosion-protected heaters, to heatcleaning solvent. Observe explosion-prevention regulationsand follow applicable safety instructions. Refer to the MSDS before using solvents to clean this equipment.The MSDS will provide use, storage, and disposal information aboutthe solvent. Read this information carefully and follow instructions.8. Action in the Event of aSystem or ComponentMalfunction9. Maintenance and Repair