Operation4-2 1997 Nordson CorporationAll rights reserved106 915CIssued 11/97Manual 21-27WARNING: Before operating, perform any and all operationalchecks on your delivery system and the spray gun. Failure toobserve this warning could result in personal injury, death, orequipment damage.WARNING: Wear protective clothing, saftey goggles, andapproved respiratory protection. Failure to observe may resultin serious injury.Before operating the spray gun, perform the following tasks:1. Perform the necessary tasks to start up the fluid delivery system.2. Check all fluid and air lines for leaks.WARNING: Risk of electrical shock. Make sure that theelectrostatic power unit is turned off and the fluid supply hasbeen properly grounded. Failure to observe this warning mayresult in personal injury, death, or equipment damage.To set the fluid flow rate of the WM-1 spray gun, perform the followingsteps:1. See Figure 4-1. Disconnect the grounded air hose (2) from theconnector (3).2. Slide the trigger lock (4) all the way down.3. Perform the tasks necessary to set fluid pressure in the fluid deliverysystem. Use the lowest fluid pressure possible to obtain a satisfactory flowrate for your coating material. Set the fluid pressure to obtain a fluid stream which begins tobreak at 304.8−406.4 mm (12−16 in.) from the tip of the spraygun.4. Point the WM-1 spray gun into a graduated container. Pull thetrigger (5). Use a stop watch to establish the time needed to collectthe desired amount of fluid.2. Preparation3. Setting Flow Rate

Issued

Introduction

Qualified Personnel

Installation

Operation

Less-Obvious Dangers

Action in the Event of a System or Component Malfunction

Manual

Material and Solvent Precautions

Disposal

Connections and Controls

Standard Nozzle Installation

Nordson Air and Fluid Hose Installations

Preparation

Spraying the Substrate

Troubleshooting 1. Introduction

Troubleshooting Procedures

Spray Pattern Faults

Repair 1. Introduction

Disassembly

Packing Cartridge and Fluid Needle

Air Valve

Assembly

Final Assembly

Parts 1. Introduction

WM-1 Manual Waterborne Air Spray Gun without Hoses

Tools Illustration for WM-1 Manual Waterborne Air Spray Gun without Hoses

WM-1 Manual Waterborne Air Spray Gun with Hoses

Tools Illustration for WM-1 Manual Waterborne Air Spray Gun with Hoses

Kit Parts List

Air Valve Service Kit

Fluid Seal Service Kit

Fluid and Air Seal Service Kits Illustration

Accessory Parts List

Fluid and Grounded Air Hose Accessories Illustration

specifications

declaration of conformity

Nordson WM-1 Customer Product Manual

WM-1