102 Testing ISDN BRI functions2 After the call-originating ISDN BRI terminal receives anacknowledgment that the receiving ISDN BRI terminal is ready, thecall-originating ISDN BRI terminal can begin transmitting packetdata.3 Verify that the transmitted data has been received successfullyby checking the transmitted information for accuracy. Read theinformation on the screen or print it on the local printer.4 Perform this test between two ISDN BRI terminals on the same MPHfor local transmission and between a system ISDN BRI terminaland a remote ISDN BRI terminal over the Packet Switched DataNetwork (PSDN).5 Release the connection.—End—Procedure 40Perform a B-channel Switched Virtual Circuit packet data transmission testusing an MPHStep Action1 From an ISDN BRI B-channel packet data terminal, dial the NetworkTerminal Numbers (NTNs) as configured in LD 27. Establish anactive call connection.2 After the call-originating ISDN BRI terminal receives anacknowledgment that the receiving ISDN BRI terminal is ready, thecall originating ISDN BRI terminal can begin transmitting packet data.3 Verify that the transmitted data has been received successfullyby checking the transmitted information for accuracy. Read theinformation on the screen or print it on the local printer.4 Perform this test between two ISDN BRI terminals on the same MPHfor local transmission and between a system ISDN BRI terminal anda remote ISDN BRI terminal over the packet data network.5 Release the connection.—End—Nortel Communication Server 1000ISDN Basic Rate Interface Installation and CommissioningNN43001-318 01.02 StandardRelease 5.0 20 June 2007Copyright © 2003-2007, Nortel Networks.
