Nortel 1000 Installation And Commissioning Manual

Also see for 1000 Con?guration guide: Brochure Reference User manual Overview User guide

Contents

Nortel 1000 Installation And Commissioning Manual Manual pdf 21 page image

Installing ISDN BRI hardware for line applications 21Procedure 3Installing the MISPStep ActionOnce covers have been removed and card slot locations selected for ISDNBRI cards, install the MISP cards.1 Hold the MISP by its card-locking devices. Squeeze the tabs tounlatch the card-locking devices and lift the tabs out and away fromthe card.2 Insert the MISP into the selected card slot of the module so itengages the card guides in the module.3 Slide the MISP into the module until it engages the backplaneconnector.4 Push the MISP firmly into the connector using the locking devices aslevers by pushing them toward the card’s front panel.5 Push the tabs firmly against the front panel of the card so they latchto the front lip in the module and to the post on the card.6 Observe the red LED on the MISP faceplate.• If the red LED lights and stays lit continuously without flashingthree times, the card is defective. Remove the MISP, choose anew MISP, and repeat the installation procedure.• If the red LED lights, flashes three times, and turns off, theMISP is operating correctly and is configured and enabled. Goto step 7.• If it lights, flashes three times, and stays lit continuously, theMISP is operating correctly but is not configured and enabled.Go to step 7.7 Repeat steps 1 through 6 for each MISP requiring installation.—End—Procedure 4Removing the MISPStep ActionPerform the following steps to remove the MISP.Nortel Communication Server 1000ISDN Basic Rate Interface Installation and CommissioningNN43001-318 01.02 StandardRelease 5.0 20 June 2007Copyright © 2003-2007, Nortel Networks.