Nortel 1000BASE-XD Using Manual

Also see for 1000BASE-XD: Installation guide

Contents

Preface204515-C xviiRelated PublicationsFor more information about using the Passport management software or otherPassport 8000 series equipment, refer to the following publications:• Getting Started with the Passport 8100 Management Software(part number 207311-C)Provides instructions to install management software and describes generaluse of the management software.• Reference for the Passport 8000 Series Management Software SwitchingOperations (part number 207414-C)Describes how to use Device Manager software to configure and managelayer 2 (switching) functions, including procedures and illustrations of thesoftware user interface.• Reference for the Passport 8000 Series Command Line Interface SwitchingOperations (part number 207308-C)Describes the command line interface (CLI) commands and parameters. Mostconfiguration tasks that can be performed using the management software canalso be done using the command line interface.• Networking Concepts for the Passport 8000 Series Switch(part number 207307-C)Provides general information and description of how a Passport routingswitch handles various networking features, such as VLANs and Multi-LinkTrunking.separator ( > ) Shows menu paths.Example: Protocols > IP identifies the IP option on theProtocols menu.vertical line ( | ) Separates choices for command keywords andarguments. Enter only one of the choices. Do not type thevertical line when entering the command.Example: If the command syntax is:show ip {alerts | routes}, you enter either:show ip alerts or show ip routes, but not both.