Nortel 2340 Configuration Manual

Also see for 2340: Command line interface guide Installation guide

Contents

Nortel 2340 Configuration Manual Manual pdf 27 page image

Nortel WLAN Location Engine 2340 Web GUI 27Nortel WLAN - Location Engine 2340 Configuration - Using InterfacesLocation AP list will show names (or IP address if the Location AP has not yet been given a name) and a status color asshown below.Green: The Location AP is responding frequently to server requests. If the number of devices seen by a Location APseems low (the number inside the green box), check the Location APs antenna connection.Yellow: The Location AP has not responded for 10 seconds, indicating intermittent network coverage.Red: The Location AP is not visible to the server, due to a network problem or malfunctioning or unplugged LocationAP.After correcting a malfunctioning Location AP, refresh the page to verify that the status is green. If not, check with thenetwork administrator to verify that the network port is live. You can also use the Refresh Location AP Status at thebottom of the page to get periodic updates of Location AP status.Editing, adding, and removing Location APYou can edit, add, and remove the location AP. To do this, follow the below procedures.To edit an Location AP1 Click on Location AP from the Location AP list.2 The right hand pane will display a Name, Description and IP Address as shown below.Edit the information and click Save.3 You can assign a name, that indicates shorthand information about the Location APs location (such as‘3rd Floor NE 1’). The description filed can be used to add even more detailed information, such asAbove Accounts Payable desks.