Nortel WLAN Location Engine 2340 Web GUI 49Nortel WLAN - Location Engine 2340 Configuration - Using InterfacesSpecifying SNMP propertiesUsing the System Settings Page, Notifications Tab to Specify SNMP Trap Properties as shown below.SNMP1 and SNMP2• Destination Host: The IP address of the machine which can receive the trap.• Destination Port (default is 162): The default can be accepted.• SNMP Version: Select the version in use, either v2c or v3.• SNMP Community (specify only if using SNMP Version 2c): Specify the same community name here as on thedestination host.SNMP Version 3• Use Authentication: Check to guarantee that the trap is coming from the Nortel WLAN Location Engine (to thwartspoofing).• Use Privacy/Encryption (Requires Authentication): Check to guarantee that the trap cannot be intercepted.• Authentication Protocol: Specify the same protocol as on the destination host.• Username: Any valid username on the destination host.• Authentication Pass phrase: Set only if Use Authentication is checked.• Privacy Pass phrase (Defaults to Authentication Pass phrase): Specify a secure password only if Use Privacy/Encryption is checked.• Context Engine ID: Any ID except one for another originator of traps.• Context Name: Not currently used.
