10 Safety InformationNN47250-306 (324121-A Version 01.01)Safety InformationEmissions disclaimerTo ensure EMC (Electromagnetic Compatibility) compliance with your local regional rules and regulations, the finalconfiguration of your end system product may require additional EMC compliance testing.See Appendix , “Regulatory and Certification Information” for product Safety and EMC regulatory compliance informa-tion. This is an FCC (Federal Communications Commission) Class A device.Intended usesThis product was evaluated as Information Technology Equipment (ITE), which may be installed in Central Offices,Telecommunication Centers, offices, schools, computer rooms, and similar commercial type locations. The suitability ofthis product for other product categories and environments (medical, industrial, telecommunications, residential, alarmsystems, test equipment, etc.), other than an ITE application, may require further evaluation.Warning! Although you may be using this guide or another resource as areference, before working with your WLE server product, pay close attention tothese safety instructions. You must adhere to the assembly instructions in thisguide to ensure and maintain compliance with existing product certificationsand approvals. Use only the described, regulated components specified in thisguide. Use of other products/components will void the UL listing and otherregulatory approvals of the product and will most likely result in noncompliancewith product regulations in the region(s) in which the product is sold.Warning! Anchor the equipment rack: The equipment rack must be anchoredto an unmovable support to prevent it from falling over when one or moreservers are extended in front of the rack on slides. You must also consider theweight of any other device installed in the rack. A crush hazard exists shouldthe rack tilt forward which could cause serious injury.