Nortel 2340 Installation Manual

Also see for 2340: Command line interface guide Configuration guide

Contents

Nortel 2340 Installation Manual Manual pdf 34 page image

34 Software Installation of WLAN Location Engine 2340NN47250-306 (324121-A Version 01.01)Cabling the WLAN Location Engine 2340To connect the cable to Location Engine, follow these steps:1 Connect the power cord.2 Connect an Ethernet cable from the network interface port labeled ‘LAN 1’ on the rear of the appliance toyour network.3 Connect the power cable and power the appliance with the front power button. Example: HypertermSetting up the WLAN Location Engine 2340To setup the Location Engine, follow the below procedures:Determining WLE2340 IP Address and Administration URLTo determine the initial WLE2340 IP address and administration URL, you can do the following:1 Connect the provided Serial Cable to the appliance and machine which is running the appropriateterminal emulation software (Example: Hyperterm, Minicom).2 Set the terminal software configuration as follows:• Baud rate: 9600• Data Bits: 8• Parity: None• Stop Bits: 1• Flow Control: None3 At the login prompt, enter the username admin and at the console prompt, password is not required.4 At the command prompt, type the command ‘show interface eth0’.5 Record the IP address (eth0 network interface) displayed.Logging to WLE2340 via Initial Administration GUIThe WLE2340 Administration uses Web-based interfaces, that allows you to configure and maintain the WLE2340. Tologin, you can do the following:Note. By default, the appliance is configured for DHCP.Note. For more information about the initial sign-in to WLE2340 Console port CLI, seehe Nortel WLAN - Location Engine 2340 Command Line Interface.