Nortel 2382 Configuration Manual

Also see for 2350: Configuration guide Read me Quick start guide User guide Reference guide

Contents

Installing and connecting a WSS 61Nortel WLAN—Security Switch 2300 Series Installation and Basic Configuration GuideFigure 17. Mini-GBIC removal from 2382 SwitchTo install a mini-GBIC:1 1 Insert the mini-GBIC into a mini-GBIC slot on the front panel until it clicksinto place.2 2 Remove the protective covering(s) from the port connector(s).3 3 Insert the network cable.4 Observe the LED next to the mini-GBIC port:• If the LED is green, the 1000-Mbps link is operational.• If the LED is unlit, the link is not operational. Check the cable and verify that the device at the otherend of the link is operational.To remove a mini-GBIC:1 Remove the network cable(s).2 Insert the protective covering(s) into the port connector(s).3 Pull the bail latch on the mini-GBIC forward, away from the MX switch, to unlock it from the front panel.4 Grasping the bail latch, pull the mini-GBIC out of the slot.Note. For 1000BASE-SX or 1000BASE-LX fiber, make sure you insert the twocable ends in the proper sides (transmit or receive). Otherwise, the link does notwork.Grasp bail latch andpull to remove mini-GBIC.