Nortel 5500 series Installation Manual

Also see for 5500 series: Cli manual Product support bulletin Installation

Contents

Nortel 5500 series Installation Manual Manual pdf 45 page image

Setting IP parameters for the Nortel Ethernet Routing Switch 5500 Series 4510 Initial IP configuration is now complete. To continue withconfiguration operations, select the appropriate menu item. Todisconnect from the switch select Logout from the main menu.—End—Setting IP Parameters using the console port and CLITo set IP parameters using the console port and Command Line Interface,perform the following tasks:Step Action1 Connect a terminal to the console port of the switch.Any terminal or PC with an appropriate terminal emulator can beused as the management station. " Terminal emulation settings"(page 45)" Terminal emulation settings" (page 45) lists theparameters that must be used with any terminal emulation softwareused to connect to the switch.Terminal emulation settingsProperty ValueBaud Rate 9600 bpsData Bits 8Stop Bits 1Parity NoneFlow Control NoneA console cable and connector to match the male DTE connector(DB-9) on the switch is required to connect the terminal to the switchconsole port.2 Set the terminal protocol on the terminal or terminal emulationprogram to VT100 and VT100/ANSI.3 Connect to the switch using the terminal or terminal emulationapplication.4 After the Nortel banner is displayed, press CTRL + Y to display themain menu. The version of the main menu displayed is dependenton whether the switch is part of a standalone or stacked switchconfiguration. "Standalone switch main menu" (page 46)"Standaloneswitch main menu" (page 46) illustrates the main menu for astandalone configuration and "Stacked switch main menu" (pageNortel Ethernet Routing Switch 5500 SeriesInstallationNN47200-300 2.00 Standard5.0 7 July 2006Copyright © 2005 - 2006, Nortel Networks Nortel Networks Confidential.