Document status: StandardDocument version: 02.02Document date: 7 July 2008Copyright © 2005-2007, Nortel NetworksAll Rights Reserved.Sourced in Canada and the United States of AmericaThis document is protected by copyright laws and international treaties. All information, copyrights and any otherintellectual property rights contained in this document are the property of Nortel Networks. Except as expresslyauthorized in writing by Nortel Networks, the holder is granted no rights to use the information contained herein andthis document shall not be published, copied, produced or reproduced, modified, translated, compiled, distributed,displayed or transmitted, in whole or part, in any form or media.The information in this document is subject to change without notice. The statements, configurations, technicaldata, and recommendations in this document are believed to be accurate and reliable, but are presented withoutexpress or implied warranty. Users must take full responsibility for their applications of any products specified in thisdocument. The information in this document is proprietary to Nortel Networks Inc.Statement of conditionsIn the interest of improving internal design, operational function, and/or reliability, Nortel Networks Inc. reserves theright to make changes to the products described in this document without notice.Nortel Networks Inc. does not assume any liability that may occur due to the use or application of the product(s) orcircuit layout(s) described herein.International regulatory statements of conformityThis is to certify that the Nortel Networks 8000 Series chassis and components installed within the chassis wereevaluated to the international regulatory standards for electromagnetic compliance (EMC) and safety and were foundto have met the requirements for the following international standards:• EMC - Electromagnetic Emissions – CISPR 22, Class A• EMC - Electromagnetic Immunity – CISPR 24• Electrical Safety – IEC 60950, with CB member national deviationsFurther, the equipment has been certified as compliant with the national standards as detailed below.National electromagnetic compliance (EMC) statements of complianceFCC statement (USA only)This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonableprotection against harmful interference when the equipment is operated in a commercial environment. Thisequipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance withthe instruction manual, it may cause harmful interference to radio communications. Operation of this equipmentin a residential area is likely to cause harmful interference, in which case users will be required to take whatevermeasures may be necessary to correct the interference at their own expense.ICES statement (Canada only)Canadian Department of Communications Radio Interference RegulationsThis digital apparatus (8000 Series chassis and installed components) does not exceed the Class A limits forradio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the CanadianDepartment of Communications.