Managing cables for the Ethernet Routing Switch 8000 Series chassis 95Managing cables: 8010, 8006, 8003 chassis3 Route the cable to the termination panel, loosely fastening the cablewith Velcro straps or sheet fiber along the path.4 Fasten the connector onto the termination panel end of the cable.Use the instructions supplied with the connector. If you are usingcables manufactured by Nortel, the connectors are already fastenedto predetermined lengths of cable.5 Label the unconnected end of the cable with the node identifier (fromsite records) and the shelf, cage, slot, and port number.6 When all the transmitting cables from the same module areconnected to the termination panel, use Velcro straps or sheet fiberwrapped around the cables to manage them.7 Using scissors, cut a section of the sheet fiber that is wide enough towrap around the cables.8 Using scissors, round the corners of the sheet fiber section.9 Loosely wrap the sheet fiber and secure it using lacing cord or tiewraps ("Wrapping cables with sheet fiber and securing with lacingcord" (page 96)).Nortel Metro Ethernet Routing Switch 8600Installation — ModulesNN46220-306 02.02 Standard4.2 7 July 2008Copyright © 2005-2007, Nortel Networks.
