38 Ethernet module configuration using the CLI2 Configure Auto-Negotiation:config ethernet auto-negotiate3 For RS module 10/100/1000 Mbit/s ports, configure CANA:auto-negotiate-advertisements <10-full|10-half|100-full|100-half|1000-full|1000-half|default|none>To use CANA, you must enable autonegotiation.4 If you do not use autonegotiation, then set the duplex mode andport speed:config ethernet duplex config ethernet speed <10|100|1000>5 Configure the other parameters as required.6 Ensure that your configuration is correct by using one of thefollowing commands:config ethernet infoshow ports info l1-config--End--Variable definitionsUse the following table to help you configure 10/100/1000 Mbit/s Ethernetport operational parameters using the config ethernet command.Variable Valueauto-negotiateEnables or disables autonegotiation.auto-negotiate-advertisements<10-full|10-half|100-full|100-half|1000-full|1000-half|default|none>Specifies the CANA advertisement to send.Only R and RS module 10/100/1000 Mbit/scopper ports can use CANA. You must enableautonegotiation to use CANA.duplex Specifies half- or full-duplex mode. Appliesonly to 10/100/1000 Mbit/s ports; 1 and 10Gbit/s ports must use full-duplex mode.name Specifies a name for the port.preferred-phyFor duplex connectors, specifies which lineand connector is active: left or right.Nortel Ethernet Routing Switch 8600Configuration — Ethernet ModulesNN46205-503 04.01 21 December 2009Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
