Nortel 8600 Configuration Manual

Also see for Passport 8600 Series: Reference guide Installation Product brief Installing Commissioning

Contents

58 Ethernet module configuration using the NNCLI2 Enable flow control pause0:flowcontrol pause03 Configure the flow control pause timer:flowcontrol pause-time <0...65535>4 For LAN/WAN modules, configure the mode:wan-mode enableWhen you configure multiple ports of the 8683XZR module toWAN mode, the framing type and clock mode must be the samefor all the WAN mode ports. Mixed configurations for multipleWAN mode enabled ports is not supported.5 If the mode is WAN, configure the framing type:framing 6 For WAN modules, configure the clock source:clock source 7 Use the following variable definitions table to configure otherparameters as required.--End--Variable definitionsUse the following table to help you configure Ethernet port operationalparameters. These commands are available in Interface Configurationmode.Variable Valueclock sourceline mode uses the recovered Receive (Rx)clock to generate the Transmit (Tx) clock.internal mode uses the onboard oscillatorto generate the Tx clock. The default valueis internal. Only applicable to WAN 10 Gbit/sports.The default form of this command is defaultclock source.flowcontrol [port] pause0When tx-flow-control is enabled andflowcontrol pause0 is enabled, theTX port transmits MAC control PAUSEframes with a timer value of 0 to indicate toits link partner to resume transmission. Thedefault is enable. This parameter applies onlyto 1 and 10 Gigabit Ethernet ports.Nortel Ethernet Routing Switch 8600Configuration — Ethernet ModulesNN46205-503 04.01 21 December 2009Copyright © 2008-2009 Nortel Networks. All Rights Reserved.