|
60 Ethernet module configuration using the NNCLIVariable ValueUse port to change other portsto the same settings.The default form of this command is defaulttx-flow-control [port ][enable].The no form of this command is notx-flow-control [port ][enable].wan-mode [enable] [port]Enables or disables WAN mode. Thisparameter is applicable only to the 8683XZRmodule. If you enable WAN mode, the portuses SONET or SDH. Use port to change other ports to the same settings.When you configure multiple ports of the8683XZR module to WAN mode, the framingtype and clock mode must be the same for allthe WAN mode ports. Mixed configurationsfor multiple WAN mode enabled ports is notsupported.The default form of this command is defaultwan-mode [enable] [port ].The no form of this command is no wan-mode[enable] [port ].Associating a port to a VRF instanceAssociate a port to a Virtual Router Forwarding (VRF) so that the portbecomes a member of the VRF instance.You can assign a VRF instance to a port after the VRF is configured. Portsare assigned to the Global Router, VRF 0, by default.For more information about VRF Lite, see Nortel Ethernet Routing Switch8600 Configuration — IP Routing (NN46205-523).Prerequisites• You must be in Interface Configuration mode.Nortel Ethernet Routing Switch 8600Configuration — Ethernet ModulesNN46205-503 04.01 21 December 2009Copyright © 2008-2009 Nortel Networks. All Rights Reserved. PreviousNext |