76 Procedures for installation of the switch3 Verify that the module is firmly seated in the slot.4 Use the thumbscrews to fasten the faceplate to the chassis andsecure the power supply module.5 Repeat these steps for each power supply module that you mustinstall.--End--Installing DC-DC converter in a 5500 Series switchThis procedure describes the steps used to install a DC-DC converter.This procedures applies only to 5500 Series switches.PrerequisitesElectrostatic discharge can damage the components on circuit boards.When you unpack the converter module, take the following precautions toprevent damage to the board:• Do not remove the converter module from its antistatic plastic baguntil you are ready to install it. Store or ship the converter module andcomponents in antistatic packaging.• Check the converter module for damage. If you find damage, contactyour sales or customer service representative at the organization fromwhich you purchased the equipment.• Use proper grounding techniques when you install the convertermodule. You can use a foot strap and grounded mat or wear agrounded static discharge wrist strap.WARNINGRemoval of the power cord is the only way to turn off powerto 5000 Series switches. The power cord must always beconnected in a location that can be accessed quickly and safelyin case of an emergency.Procedure StepsStep Action1 Make certain you are properly grounded electrically. See"Prerequisites" (page 76).2 The 5000 Series switch has a blank plate covering the convertermodule slot on the back of the switch.Use a Phillips screwdriver to remove the screws. Pull the plategently toward you to pull the plate loose.3 Set aside the blank plate and the screws. If you remove theconverter module for any reason, be sure to reinsert the blankplate.ERS 5000 Series InstallationNN47200-300 04.0313 April 2009Copyright © 2008–2009 Nortel Networks
