IP address information configuration 852 Assign an IP address to the switch.• For a standalone switch, enter a value in the In-Band SwitchIP Address field in dotted-decimal notation.• For a stack configuration, enter a value in the In-Band StackIP Address field in dotted-decimal notation.3 In the In-Band Subnet Mask field enter the appropriate subnetmask in dotted-decimal notation.4 In the Default Gateway field, enter the appropriate defaultgateway in dotted-decimal notation.5 Press CTRL + C to return to the main menu.--End--Assigning IP parameters using the console menu and NNCLIProcedure StepsStep Action1 Connect a terminal to the console port of the switch.2 Set the terminal protocol on the terminal or terminal emulationprogram to VT100 and VT100/ANSI.3 Connect to the switch using the terminal or terminal emulationapplication.4 After the Nortel banner is displayed, press CTRL + Y to displaythe main menu.5 Select Command Line Interface. . . from the main menu.6 Enter the Global Configuration command mode using theenable and configure terminal commands.7 In the Global Configuration command mode, use the ipaddress command to set the switch or stack IP address.8 Initial IP configuration is now complete. To continue withconfiguration operations, use the appropriate CLI commands. Todisconnect from the switch use the logout command to returnto the Console Menu and select Logout from the main menu.--End--Job aidAny terminal or PC with an appropriate terminal emulator can be usedas the management station. The following table lists the parameters thatmust be used with any terminal emulation software used to connect to theswitch.ERS 5000 Series InstallationNN47200-300 04.0313 April 2009Copyright © 2008–2009 Nortel Networks
