Nortel BayStack Instant Internet 100-S User Manual

Also see for BayStack 100-S: Reference Install guide Release note Using Install guide

Contents

Chapter 7 Out-of-band management support 65Setting Up the BayStack Instant Internet 100-S Unit6 From the Bits per second list, select 115200 to set the modem speed, and thenclick OK.HyperTerminal establishes a connection to the Instant Internet unit. If theInstant Internet unit is password protected, the session begins by requesting apassword. Enter the password for the Instant Internet unit and then pressEnter.When you successfully log on, the command prompt is displayed (Figure 10) andyou can begin using remote access commands to configure the unit.Figure 10 Command promptConfiguring the Instant Internet unit through a dial-upconnectionTo configure the unit through a dial-up connection using the out-of-bandmanagement feature, you must:• Connect the modem to a PC.• Use a terminal emulation software application to configure the modemconnection settings.• Connect the modem to your Instant Internet unit.Note: If you enter an incorrect password, the message “IncorrectLogin” is displayed and you are prompted to enter a correct password.You are given two more chances before Instant Internet ends the sessionand disconnects you.BayStack Instant Internet(tm) version 7.11Copyright (c) 1995-2000 Nortel Networks Corporationii>