Nortel CallPilot Installation Manual

Also see for CallPilot: User guide Supplementary guide Configuration manual User guide Reference guide

Nortel CallPilot Installation Manual Manual pdf 20 page image

20 Chapter 2 703t server descriptionRemote access connectivityThe RS-232 COM1 connector on the rear of the 703t server provides theconnection to an external dial-up modem. The modem allows administratorsand technical support personnel to administer the 703t server from aremote location.pcAnywhere is used to establish a remote access connection to the server.Supported peripheral devicesThis section identifies external devices that are supported by the 703tserver. The following table describes the supported peripheral devices:Device DescriptionModem A 56 Kbps external modem (NTRH9078 in NorthAmerica only) provides remote access to the 703tserver. The modem connects to the RS-232 COM1connector on the rear of the server.Because the modem is an external device, it requiresits own AC power source referenced to the sameground as the 703t server and the switch to which it isconnected.Ethernet hub A 10Base-T Ethernet hub provides the ELANsubnet connection between the 703t serverand the Meridian 1 switch or CS 1000 system.The customer can supply a hub or switch fromthird-party vendors or from Nortel.Because the hub is an external device, it requiresan AC power source referenced to the same groundas the 703t server and the switch to which it isconnected.ATTENTIONTo comply with EMC requirements, a Class Ahub must be located 10 m (33 ft.) away from the703t server.Nortel CallPilot703t Server Hardware InstallationNN44200-304 01.01 Standard5.0 23 February 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.