Nortel CallPilot Installation Manual

Also see for CallPilot: User guide Supplementary guide Configuration manual User guide Reference guide

Nortel CallPilot Installation Manual Manual pdf 36 page image

36 Chapter 4 Installing the server and connecting the peripheral devicesNote 2: The DS30X cable that connects the MPB96 boards tothe MGate cards is 20 m (60 feet) long. This allows the serverto be placed in a different room from the Meridian 1 switch orCS 1000 system.2 Connect peripheral devices as described in the remainder of thischapter.—End—Preparing the modemYou require a modem to support remote dial-up access to the CallPilotserver. The modem also enables Nortel technical support to connect toyour CallPilot server for troubleshooting purposes. Nortel connects to yourserver only when you request technical assistance.Required equipmentTo install the modem, you need the following equipment:• an analog external modem that includes— an RJ-11 analog phone cord— a power adapter cord— US Robotics 56 Kbps modem (NTRH9078) (North America only)— a 25-pin male to 9-pin female shielded serial cable for your modem(A0841984)• an analog line jack• tweezers, or a screwdriver small enough to use to adjust DIP switchesModem DIP switchesSet the modem DIP switches before you connect the modem to the CallPilotserver.Note: This section applies only to the US Robotics 56 Kbps externalSportster modem. If your modem is different, refer to the documentationfor your modem.The following diagram shows the key components of the external modem,including the location and required settings of the DIP switches:Nortel CallPilot703t Server Hardware InstallationNN44200-304 01.01 Standard5.0 23 February 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.